REAR SEAT ENTERTAINMENT SYSTEM (for Seatback) Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly

DESCRIPTION

This is the display mode signal circuit between the multi-display controller sub-assembly and television display assembly RH.

WIRING DIAGRAM

A01EMZBE07

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH)


    1. Disconnect the L56 multi-display controller sub-assembly connector.

    2. Disconnect the c60 television display assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L56-9 (MD0) - c60-6 (MD0) Always Below 1 Ω
      L56-9 (MD0) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here