AUDIO AND VISUAL SYSTEM Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver

DESCRIPTION

The telematics transceiver sends a mute signal to the stereo component amplifier assembly.

The stereo component amplifier assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM

A01EMZBE08

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK TELEMATICS TRANSCEIVER


    1. A01ERF8E96
      Text in Illustration
      *a

      Component with harness connected

      (Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      P2-17 (MUTE) - Body ground

      Engine switch on (ACC), audio system is playing

      → Emergency call mode

      3.5 V or higher → Below 1 V

    NG
    OK
  2. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - TELEMATICS TRANSCEIVER)


    1. Disconnect the F73 stereo component amplifier assembly connector.

    2. Disconnect the P2 telematics transceiver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F73-2 (TMUT) - P2-17 (MUTE) Always Below 1 Ω
      F73-2 (TMUT) - Body ground Always 10 kΩ or higher

    NG
    OK
  3. CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. Reconnect the stereo component amplifier assembly connector.

    2. A01ERWLE16
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      P2-17 (MUTE) - Body ground Engine switch on (ACC) 3.5 V or higher

    NG
    OK