AUDIO AND VISUAL SYSTEM Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the multi-media module receiver assembly via this circuit.

WIRING DIAGRAM

A01EONQE58

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the F80 multi-media module receiver assembly connector.

    2. Disconnect the k1 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F80-2 (US1-) - k1-2 (UDO-) Always Below 1 Ω
      F80-3 (US1+) - k1-3 (UDO+) Always Below 1 Ω
      F80-5 (UESS) - k1-5 (UJSS) Always Below 1 Ω
      F80-2 (US1-) - Body ground Always 10 kΩ or higher
      F80-3 (US1+) - Body ground Always 10 kΩ or higher
      F80-5 (UESS) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here