REAR SEAT ENTERTAINMENT SYSTEM (for Roof) Display Signal Circuit between Radio Receiver and Television Display Assembly

DESCRIPTION

This is the display signal circuit from the multi-media module receiver assembly to the television display assembly.

WIRING DIAGRAM

A01ERG9E06

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    1. Disconnect the F77 multi-media module receiver assembly connector.

    2. Disconnect the L61 television display assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F77-1 (NTSO) - L61-20 (NTS4) Always Below 1 Ω
      F77-2 (NTSG) - L61-19 (SGN4) Always Below 1 Ω
      F77-3 (SLD2) - L61-18 (SLD4) Always Below 1 Ω
      F77-1 (NTSO) - Body ground Always 10 kΩ or higher
      F77-2 (NTSG) - Body ground Always 10 kΩ or higher
      F77-3 (SLD2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here