STEERING LINKAGE REASSEMBLY


  1. INSTALL STEERING RACK END SUB-ASSEMBLY


    1. Temporarily install the 2 steering rack ends to the power steering rack.

    2. Fill up the ball joint of the steering rack ends with MP grease.

    3. A01ERS1E01

      Using SST, install the power steering rack end (RH side) to the power steering rack.

      SST
      09922-10010
      Torque:
      without SST
      147 N*m  { 1499 kgf*cm, 108 ft.*lbf }
      with SST
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

      Tech Tips


      • Rotate SST in the direction shown in the illustration.

      • Use a torque wrench with a fulcrum length of 380 mm (15.0 in.).

    4. Using SST and a wrench, install the power steering rack end (LH side) to the power steering rack.

      SST
      09922-10010
      Torque:
      without SST
      147 N*m  { 1499 kgf*cm, 108 ft.*lbf }
      with SST
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

      Tech Tips


      • Rotate SST in the direction shown in the illustration.

      • Use a torque wrench with a fulcrum length of 380 mm (15.0 in.).

  2. INSTALL NO. 1 STEERING RACK BOOT

    A01EN2TE01

    1. Apply silicon grease to the inside of the small opening of the boot.

    2. Install the 2 boots to the groove on the rack housing.

  3. INSTALL STEERING RACK BOOT CLAMP RH

    A01EOV5E02

    1. Using SST, install a new boot clamp as shown in the illustration.

      SST
      09521-24010
      Standard clearance
      3.0 mm (0.119 in.) or less

      Note

      Be careful not to damage the boot.

  4. INSTALL STEERING RACK BOOT CLAMP LH

    Tech Tips

    Use the same procedures described for the RH side.

  5. INSTALL STEERING RACK BOOT CLIP RH

    A01EQZQE01

    1. Using pliers, install the boot clip.

      Note

      Make sure that the claws of each clip are positioned within the area shown in the illustration.

  6. INSTALL STEERING RACK BOOT CLIP LH

    Tech Tips

    Use the same procedures described for the RH side.