STEERING WHEEL INSTALLATION


  1. INSTALL STEERING WHEEL ASSEMBLY

    A01EQVCE01

    1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  2. INSTALL STEERING PAD


    1. A01EQYD

      Support the steering pad with one hand.

    2. Connect the 2 connectors to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A01ES8Q

      Attach the 2 claws to install the cover.

  4. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A01EOLU

      Attach the 2 claws to install the cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.