HEATED STEERING WHEEL CONTROLLER INSTALLATION


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. Install the controller with the 2 screws.

    2. Connect the 2 connectors.

  2. INSTALL STEERING PAD ASSEMBLY


    1. A01EQYD

      Support the steering pad with one hand.

    2. Connect the 2 connectors to the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.

    5. Using a T30 "TORX" socket wrench, tighten the 2 screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  3. INSTALL NO. 2 STEERING WHEEL LOWER COVER


    1. A01ES8Q

      Attach the 2 claws to install the cover.

  4. INSTALL NO. 3 STEERING WHEEL LOWER COVER


    1. A01EOLU

      Attach the 2 claws to install the cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.