PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Disable the AUTO TILT AWAY function by changing the customize parameter Click here.
Note
Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.
Tech Tips
Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.
Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE LOWER STEERING COLUMN COVER
Remove the 3 screws.
Tech Tips
Turn the steering wheel to the right and left as necessary to remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
REMOVE UPPER STEERING COLUMN COVER
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
REMOVE TILT AND TELESCOPIC MANUAL SWITCH
Disconnect the switch connector.
Using a screwdriver, detach the claw and pull out the switch.
Tech Tips
Tape the screwdriver tip before use.
Note
Pushing on the claw too hard will break the claw.