POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedures to troubleshoot the power tilt and telescopic steering column system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT

  3. CHECK CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output for LHD B
      CAN DTC is output for RHD C

      B

      Go to CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      C

      Go to CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      A

  4. CHECK FOR DTC*


    1. Check for DTCs Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      B

      Go to POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here

      A

  5. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B

    Go to step 7
    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here

    2. Data List/Active Test Click here


      NEXT

  7. REPAIR


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END