PARKING BRAKE ASSEMBLY DISASSEMBLY

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR WHEEL LH

  2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01ER8G

      Remove the 2 bolts and disconnect the rear disc brake cylinder.

      Note


      • Do not disconnect the flexible hose from the disc brake cylinder.

      • Do not twist or bend the flexible hose.

    2. Hang the disc brake cylinder with a piece of wire.

  3. REMOVE REAR DISC


    1. A01ESGPE01

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. A01EO20

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  4. REMOVE PARKING BRAKE SHOE RETURN SPRING


    1. A01ENF7E01

      Using SST, remove the return spring.

      SST
      09703-30011

  5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. A01EQU5E01

      Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

      SST
      09718-00011
    2. A01ERTW

      Disconnect the tension spring from the No. 1 parking brake shoe.

    3. A01EOXP

      Remove the No. 1 parking brake shoe and shoe adjuster screw set.

  6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. A01ESHHE01

      Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 2 parking brake shoe.

  7. REMOVE PARKING BRAKE SHOE LEVER LH


    1. A01EQJ3

      Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

    2. Remove the parking brake shoe lever.

  8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A01ERAI

      Remove the bolt and No. 3 parking brake cable.

  9. REMOVE PARKING BRAKE ANCHOR BLOCK


    1. A01EPXQ

      Remove the 2 nuts and anchor block.