PARKING BRAKE LEVER REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH (w/ Cool Box)


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH (w/ Cool Box)


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Cool Box)


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Cool Box)


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  5. REMOVE FRONT SEAT ASSEMBLY LH (w/ Cool Box)


    1. Remove the front seat assembly LH Click here.

  6. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)


    1. Remove the rear console box sub-assembly Click here.

  7. REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)


    1. Remove the cooling box assembly Click here.

  8. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY


    1. Release the parking brake lever.

    2. Disconnect the parking brake switch connector.

    3. A01ENKT

      Remove the adjusting nut.

    4. A01EN2Y

      Remove the parking brake return spring.

    5. Disconnect the No. 2 parking brake cable and No. 3 parking brake cable from the No. 1 parking brake pull rod.

    6. Remove the No. 1 parking brake pull rod, bush and compression spring from the parking brake lever.

    7. Remove the straight pin from the parking brake lever.

    8. A01EOL6

      Remove the 4 bolts and parking brake lever.

  9. REMOVE PARKING BRAKE SWITCH ASSEMBLY


    1. Remove the screw and parking brake switch.