VANE PUMP REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL RH

  4. REMOVE FRONT FENDER APRON TRIM PACKING A


    1. A01EO1I

      Using a clip remover, remove the 3 clips and fender apron seal.

  5. REMOVE V-BANK COVER SUB-ASSEMBLY (for 3UR-FE)


    1. A01EN38E01

      Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  6. REMOVE V-BANK COVER SUB-ASSEMBLY (for 1UR-FE)


    1. A01EO82E01
      Text in Illustration
      *1 Grommet
      *2 Pin
      *3 Hook
      *4 Bracket

      Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  7. REMOVE AIR CLEANER HOSE ASSEMBLY (for 3UR-FE)


    1. A01EPIO

      Disconnect the vacuum hose and No. 2 ventilation hose.

    2. Loosen the 2 hose clamps.

    3. Remove the air cleaner hose.

  8. REMOVE AIR CLEANER ASSEMBLY (for 3UR-FE)


    1. A01ENV0

      Remove the 3 bolts and air cleaner.

  9. REMOVE AIR CLEANER AND HOSE (for 1UR-FE)


    1. A01EP8F

      Disconnect the No. 2 PCV hose and No. 1 air hose.

    2. Disconnect the mass air flow meter connector and detach the clamp.

    3. Remove the 3 bolts and loosen the hose clamp, and then remove the air cleaner and hose.

  10. REMOVE FAN AND GENERATOR V BELT


    1. A01EPTXE02

      While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

      Tech Tips

      The pulley bolt for the belt tensioner has a left-hand thread.

    2. Remove the V belt.

  11. DRAIN POWER STEERING FLUID

  12. DISCONNECT SUCTION HOSE

    A01EQZI

    1. Slide the clip and disconnect the suction hose from the vane pump.

  13. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

    A01EPI8

    1. Detach the wire harness clamp and disconnect the connector.

  14. DISCONNECT PRESSURE FEED TUBE


    1. A01EOJPE01

      Remove the bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  15. REMOVE VANE PUMP ASSEMBLY

    A01EQ6F

    1. Remove the 2 bolts and vane pump.