BRAKE PEDAL (for RHD) REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    A01EQ14

    1. w/o Illumination:


      1. Detach the 7 claws and 4 clips, and remove the scuff plate.

    2. A01EOWQ

      w/ Illumination:


      1. Detach the 7 claws and 4 clips.

      2. Disconnect the connector and remove the scuff plate.

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ERF3

      Remove the 2 screws.

    2. Detach the 3 claws.

    3. Remove the under cover and disconnect the connectors.

  5. REMOVE COWL SIDE TRIM BOARD RH


    1. A01EQ1Q

      Remove the cap nut.

    2. Detach the 2 clips and remove the trim board.

  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A01EOMY

      Using a screwdriver, detach the 2 claws and open the hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01EOJD

      Remove the 2 bolts.

    3. A01EQBC

      Detach the 16 claws.

    4. A01EN2R

      Detach the 2 claws and remove the sensor.

    5. A01EQEE

      Detach the 2 claws and disconnect the 2 control cables.

    6. Remove the finish panel and then disconnect the connectors.

  7. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. A01ESFQ

      Remove the 5 bolts and driver side knee airbag.

    2. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  8. REMOVE PUSH ROD PIN


    1. A01EPYC

      Remove the clip and push rod pin from the brake pedal lever.

  9. REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. Disconnect the stop light switch connector.

    2. Remove the stop light switch Click here.

  10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A01ENN8

      Loosen the hexagon bolt.

      Tech Tips

      Hold the bolt in place and loosen the nut.

      Note

      Only loosen the nut. Do not remove the bolt or nut.

    2. Remove the bolt from the brake pedal support reinforcement.

    3. A01EOD0

      Remove the 4 nuts and brake pedal support assembly.