SKID CONTROL BUZZER INSTALLATION

INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD)
1. Connect the buzzer connector.
  
  Note
  
  Securely connect the connector.
2. Attach the clamp to install the buzzer.
  Note
  - Securely insert the clamp into the bracket.
  - If the buzzer is dropped, replace it.
INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD)
1. Connect the buzzer connector.
  
  Note
  
  Securely connect the connector.
2. Attach the clamp to install the buzzer.
  Note
  - Securely insert the clamp into the bracket.
  - If the buzzer is dropped, replace it.
INSTALL INSTRUMENT PANEL BOX ASSEMBLY
1. Connect the connectors.
2. Attach the 5 claws to install the box.
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
1. Connect the connectors.
2. Attach the 2 claws to install the sensor.
3. Attach the 2 claws to connect the 2 control cables.
4. Attach the 16 claws to install the finish panel.
5. Install the 2 bolts.
6. Attach the 2 claws to close the hole cover.
INSTALL COWL SIDE TRIM BOARD
1. Attach the 2 clips to install the trim board.
2. Install the cap nut.
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
1. Connect the connectors.
2. Attach the 3 claws to install the under cover.
3. Install the 2 screws.
INSTALL FRONT DOOR SCUFF PLATE
1. w/o Illumination:
  1. Attach the 7 claws and 4 clips to install the scuff plate.
2. w/ Illumination:
  1. Connect the connector.
  2. Attach the 7 claws and 4 clips to install the scuff plate.
INSTALL NO. 1 SWITCH HOLE BASE
1. Connect the connectors.
2. Attach the 5 claws to install the switch hole base.
INSTALL INSTRUMENT SIDE PANEL
1. Attach the 6 claws to install the side panel.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.