SKID CONTROL BUZZER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL


    1. A01EN4GE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws and remove the side panel.

  4. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01EQ09

      Detach the 5 claws.

    2. Disconnect the connectors and remove the switch hole base.

  5. REMOVE FRONT DOOR SCUFF PLATE

    A01EQ14

    1. w/o Illumination:


      1. Detach the 7 claws and 4 clips, and remove the scuff plate.

    2. A01EOWQ

      w/ Illumination:


      1. Detach the 7 claws and 4 clips.

      2. Disconnect the connector and remove the scuff plate.

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ERF3

      Remove the 2 screws.

    2. Detach the 3 claws.

    3. Remove the under cover and disconnect the connectors.

  7. REMOVE COWL SIDE TRIM BOARD


    1. A01EQ1Q

      Remove the cap nut.

    2. Detach the 2 clips and remove the trim board.

  8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A01EOMY

      Using a screwdriver, detach the 2 claws and open the hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01EOJD

      Remove the 2 bolts.

    3. A01EQBC

      Detach the 16 claws.

    4. A01EN2R

      Detach the 2 claws and remove the sensor.

    5. A01EQEE

      Detach the 2 claws and disconnect the 2 control cables.

    6. Remove the finish panel and then disconnect the connectors.

  9. REMOVE INSTRUMENT PANEL BOX ASSEMBLY


    1. A01ENPQ

      Detach the 5 claws.

    2. Remove the box and then disconnect the connectors.

  10. REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD)


    1. A01ER2C

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.

  11. REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD)


    1. A01ERMT

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.