YAW RATE AND DECELERATION SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH (w/ Cool Box)


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH (w/ Cool Box)


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Cool Box)


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Cool Box)


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  5. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE FRONT SEAT ASSEMBLY LH (w/ Cool Box)


    1. Remove the front seat assembly LH Click here.

  8. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)


    1. Remove the rear console box sub-assembly Click here.

  9. REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)


    1. Remove the cooling box assembly Click here.

  10. REMOVE YAW RATE SENSOR


    1. Disconnect the sensor connector and then detach the clamp from the sensor bracket.

      A01EOASE01
      A01EP21E01

    2. Remove the 2 bolts and sensor.