FRONT SPEED SENSOR REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL

  4. REMOVE FRONT SKID CONTROL SENSOR WIRE LH


    1. A01ER3D

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. A01ERSZ

      Remove the 2 bolts and 2 harness clamps.

    5. A01EQWNE01

      Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.

  5. REMOVE FRONT SPEED SENSOR LH


    1. Type A:


      1. A01EO7EE01

        Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.

        Note

        Pull out the sensor while trying as much as possible not to rotate it.

    2. Type B:


      1. Remove the bolt and speed sensor from the knuckle.

        Note

        Pull out the sensor while trying as much as possible not to rotate it.

  6. REMOVE FRONT SKID CONTROL SENSOR WIRE RH


    1. A01ES1U

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. A01ESIH

      Disconnect the connector.

    5. Detach the connector from the skid control sensor clamp.

    6. Remove the bolt and skid control sensor clamp.

    7. Remove the 2 bolts and 2 harness clamps.

    8. A01EO5K

      Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

  7. REMOVE FRONT SPEED SENSOR RH


    1. Type A:


      1. A01EOW1E01

        Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.

        Note

        Pull out the sensor while trying as much as possible not to rotate it.

    2. Type B:


      1. Remove the bolt and speed sensor from the knuckle.

        Note

        Pull out the sensor while trying as much as possible not to rotate it.