VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1282

DTC Code DTC Name
C1282 Center Differential Lock Position Switch

DESCRIPTION

DTC C1282 is stored only in test mode.

DTC Code DTC Detection Condition Trouble Area
C1282 Stored during test mode.

  • Harness or connector

  • Transfer system

WIRING DIAGRAM

A01EN78E15

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK DTC


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1340 is not output A
      DTC C1340 is output B

    B

    GO TO DTC C1340 Click here

    A

  2. CHECK TEST MODE DTC


    1. Switch the vehicle to test mode, perform the center differential lock signal check, and then check that the Test Mode (Signal Check) DTC C1282 is cleared Click here.

      Result
      Result Proceed to
      Test Mode DTC C1282 is cleared A
      Test Mode DTC C1282 is not cleared B

    B

    CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR) Click here

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

  3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)


    1. Disconnect the A24 skid control ECU (master cylinder solenoid) connector.

    2. Disconnect the A27 4 wheel drive control ECU connector.

    3. Disconnect the C43 transfer shift actuator assembly connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A24-27 (EXI) - A27-14 (P1) Always Below 1 Ω
      A24-27 (EXI) - C43-3 (CDL) Always Below 1 Ω
      A24-27 (EXI) - Body ground Always 10 kΩ or higher
      C43-7 (GND1) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) Click here