SIDE TURN SIGNAL LIGHT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE OUTER REAR VIEW MIRROR LH

    Click here

  2. REMOVE OUTER MIRROR LH

    A01EQ1M

    1. Push the upper part of the mirror surface and tilt it.

    2. Using a moulding remover, detach the 4 claws and separate the outer rear view mirror glass from the mirror body.

      Tech Tips

      Apply protective tape to the outer rear view mirror to prevent it from being damaged.

    3. A01EP9R

      Disconnect the 3 connectors and remove the mirror glass.

  3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. A01ERJ1E02

      Remove the outer mirror cover.

      Tech Tips

      Be sure to detach the claws of the outer mirror cover in the order shown in the illustration.


      1. A01EMUXE01
        Text in Illustration
        *1 Protective Tape

        Using 2 screwdrivers, detach the 2 claws.

        Tech Tips

        Tape the screwdriver tip before use.

      2. Insert a screwdriver into the slot as shown in the illustration and push on the outer mirror body to create a space between the outer mirror body and outer mirror cover.

        Note

        Be careful not to break the ribs.

        Tech Tips

        Tape the screwdriver tip before use.

        A01ERGHE01
        Text in Illustration
        *1 Protective Tape *2 Rib
        *a Inner Side of Outer Mirror Cover - -
      3. A01ER5AE01
        Text in Illustration
        *1 Protective Tape

        Insert a moulding remover into the space made between the outer mirror body and outer mirror cover.

        Note

        Do not insert the moulding remover more than 4 mm (0.157 in.).

        Tech Tips

        Tape the moulding remover before use.

        Standard
        Area Specified Condition
        a 4mm
      4. A01ER5EE01
        Text in Illustration
        *1 Protective Tape

        Slide the moulding remover downwards as shown in the illustration to detach the 2 claws.

        Note


        • Do not insert the moulding remover more than 4 mm (0.157 in.).

        • Do not slide the moulding remover past the point approximately 40 mm (1.57 in.) from the bottom edge of the outer mirror cover as the outer mirror body will become damaged.

        Standard
        Area Specified Condition
        a 40mm
        b 4mm

      5. Remove the moulding remover B.

      6. A01EPRIE02
        Text in Illustration
        *1 Protective Tape
        *a Lower Side

        Apply protective tape to the areas of the body cover and outer mirror cover as shown in the illustration.

      7. Insert a moulding remover B between the outer mirror cover and outer mirror body as shown in the illustration and detach the claw.

      8. A01EO4LE01
        Text in Illustration
        *1 Protective Tape

        Using a screwdriver, detach the claw.

      9. A01ES5A

        Detach the 2 claws and remove the outer mirror cover.

        Note

        When removing the cover, be careful not to damage the side turn signal light assembly or cover.

    2. A01EQ7T

      Remove the 3 screws and side turn signal light assembly LH.

    3. Disconnect the connector.