REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. A01EO4I

      Temporarily install the rear wiper motor assembly with the 3 bolts.

    2. Tighten the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the connector.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A01EPD7E01

      Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

  3. INSTALL REAR WIPER ARM


    1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

    2. A01EO7PE01

      Clean the wiper pivot serration with a wire brush.

    3. A01EMXSE01

      Set the head of the blade on the defogger line.

    4. Install the rear wiper arm with the nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Close the cover.

  4. INSTALL BACK DOOR GARNISH


    1. A01EQR4

      Attach the 14 clips to install the back door garnish.

  5. INSTALL BACK DOOR SIDE GARNISH LH


    1. A01ER4G

      Attach the 3 clips to install the back door side garnish.

  6. INSTALL BACK DOOR SIDE GARNISH RH


    1. w/o Power Back Door:

      Tech Tips

      Use the same procedures described for the LH side.

    2. w/ Power Back Door:


      1. A01EPSU

        Attach the clip and 2 claws to install the back door side garnish.

  7. INSTALL CENTER BACK DOOR GARNISH


    1. A01ERXU

      Attach the 5 clips and 2 claws to install the back door garnish.