FUEL LID LOCK CONTROL CABLE ASSEMBLY (for LHD) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT FLOOR CARPET ASSEMBLY

    Click here

  4. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  5. REMOVE NO. 1 WOOFER BOX SPEAKER ASSEMBLY (for 19 Speakers)


    1. Disconnect the connector.

    2. A01ENTM

      Remove the 5 bolts and box speaker.

  6. REMOVE FUEL FILLER OPENING LID LOCK RETAINER

    A01ERA2

    1. Turn the cable counterclockwise and remove the cable from the retainer.

    2. A01EO92

      Turn the lock retainer counterclockwise and remove the lock retainer.

  7. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY


    1. A01ES96

      Detach the 2 claws.

    2. Disconnect the fuel lid lock control cable and remove the fuel lid lock open lever.

  8. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


    1. Using a screwdriver, disconnect the clamps shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Remove the lock control cable.

      A01EN1M