OUTER REAR VIEW MIRROR INSTALLATION

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

    A01ERRFE02

    1. Attach the claw to install the mirror.

    2. Install the 3 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    3. Attach the clamp.

    4. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. Connect the connector.

    2. A01EO3L

      Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.

    3. A01EMZN

      Attach the 4 claws and 14 clips to install the front door trim board sub-assembly LH.

    4. Install the 2 screws.

  3. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH


    1. Attach the clip and claw to install the front lower door frame bracket garnish LH.

  4. INSTALL FRONT UPPER ARMREST BASE PANEL


    1. Connect the connector.

    2. Attach the 5 claws to install the front upper armrest base panel LH.

  5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. Attach the 3 claws to install the front door inside handle bezel plug LH.