POWER BACK DOOR CONTROL SWITCH REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. REMOVE INSTRUMENT SIDE PANEL LH


    1. A01EN4GE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws and remove the side panel.

  2. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01EQ09

      Detach the 5 claws.

    2. Disconnect the connectors and remove the switch hole base.

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01ERF3

      Remove the 2 screws.

    2. Detach the 3 claws.

    3. Remove the under cover and disconnect the connectors.

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01EO0Q

      Detach the 8 claws.

    2. Disconnect the connector and remove the panel pad.

  5. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH


    1. A01ER40

      Remove the clip.

    2. Detach the clip and remove the cover.

  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. A01EOMY

      Using a screwdriver, detach the 2 claws and open the hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01EOJD

      Remove the 2 bolts.

    3. A01EQBC

      Detach the 16 claws.

    4. A01EN2R

      Detach the 2 claws and remove the sensor.

    5. A01EQEE

      Detach the 2 claws and disconnect the 2 control cables.

    6. Remove the finish panel and then disconnect the connectors.

  7. REMOVE INSTRUMENT PANEL BOX ASSEMBLY


    1. A01ENPQ

      Detach the 5 claws.

    2. Remove the box and then disconnect the connectors.

  8. REMOVE COMBINATION SWITCH ASSEMBLY


    1. A01ERLZ

      Detach the 4 claws and remove the switch.