FRONT CONSOLE BOX (w/ Cool Box) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  5. REMOVE FRONT SEAT ASSEMBLY LH


    1. Remove the front seat assembly LH Click here.

  6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A01EO0Q

      Detach the 8 claws.

    2. Disconnect the connector and remove the panel pad.

  7. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH


    1. A01ER40

      Remove the clip.

    2. Detach the clip and remove the cover.

  8. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A01EP7O

      Detach the 9 claws and remove the panel pad.

  9. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH


    1. A01EO0O

      Detach the clip and remove the cover.

  10. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01ENTE

      Twist the shift lever knob in the direction indicated by the arrow and remove it.

  11. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01EQSF

      Detach the 8 claws.

    2. Disconnect the connectors and remove the panel.

  12. REMOVE PARKING BRAKE HOLE COVER


    1. A01EOWR

      Detach the 6 claws and remove the cover.

  13. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY


    1. A01EPMF

      Detach the 4 claws and remove the box.

  14. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01ENG7

      Detach the 13 claws.

    2. Disconnect the connectors and remove the console panel.

  15. REMOVE NO. 1 COOLER COVER


    1. A01ENGO

      Detach the clamp on the lower part of the cooler cover, and then pull the cooler cover upward to remove it.

  16. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    1. A01ESG6E01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Remove the end panel and disconnect the connectors and 3 clamps.

  17. REMOVE COOLING BOX ASSEMBLY

    A01EPBK

    1. Remove the 4 bolts and 2 screws.

    2. Remove the 2 bolts and disconnect the 2 cooler pipes.

    3. Remove the 2 O-rings from the cooler pipes.

    4. Disconnect the connector.

    5. Detach the 2 claws and remove the cooling box.