OIL LEVEL SENSOR REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01EQP2

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A01EN7K

      Remove the 10 bolts and No. 1 engine under cover.

  4. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01ERKF

      Remove the 2 bolts and No. 2 engine under cover.

  5. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. A01EPCF

      Remove the 2 bolts and No. 2 engine under cover seal.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  6. DISCONNECT OIL COOLER PIPE ASSEMBLY


    1. A01EORU

      Remove the 2 bolts and disconnect the oil cooler pipe.

  7. REMOVE ENGINE OIL LEVEL SENSOR


    1. Disconnect the oil level sensor connector.

    2. A01EQJU

      Remove the 4 bolts and oil level sensor.

    3. A01ESJZE01
      Text in Illustration
      *1 Cutting Position
      *2 Supply Part

      Cut off the gasket as shown in the illustration.

    4. Remove the gasket from the oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.