OIL PRESSURE SENSOR REMOVAL


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01EQP2

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A01EN7K

      Remove the 10 bolts and No. 1 engine under cover.

  4. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. A01EPCF

      Remove the 2 bolts and No. 2 engine under cover seal.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  5. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. A01EN3Y

      Disconnect the sender gauge connector.

    2. A01ERH7

      Remove the oil pressure sender gauge.