FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) INSTALLATION


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01EOMR

      Install a new gasket to the sender gauge.

    2. Install the sender gauge with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    3. Connect the sender gauge connector.

  2. INSTALL REAR FLOOR SERVICE HOLE COVER


    1. A01EPM3

      Install the service hole cover with new butyl tape.

  3. INSTALL REAR NO. 7 AIR DUCT


    1. A01ER8TE01

      Attach the 4 clips to install the air duct.

      Tech Tips

      Attach the clips in the order shown in the illustration.

  4. INSTALL REAR FLOOR MAT ASSEMBLY


    1. A01EQ99

      Attach the 5 clips to install the floor mat.

  5. INSTALL REAR SEAT ASSEMBLY


    1. Install the rear No. 1 seat assembly and rear No. 2 seat assembly Click here.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.