FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR SEAT ASSEMBLY


    1. Remove the rear No. 1 seat assembly and rear No. 2 seat assembly Click here.

  3. REMOVE REAR FLOOR MAT ASSEMBLY

    A01EQ99

    1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

      Tech Tips

      Fold back the floor mat so that the rear No. 7 air duct can be removed.

  4. REMOVE REAR NO. 7 AIR DUCT


    1. A01ER8T

      Detach the 4 clips and remove the air duct.

  5. REMOVE REAR FLOOR SERVICE HOLE COVER

    A01EPM3

  6. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A01EOMR

      Disconnect the sender gauge connector.

    2. Remove the 5 screws and sender gauge.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    3. Remove the gasket from the sender gauge.