FUEL PRESSURE REGULATOR INSTALLATION


  1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    1. A01EPYV

      Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator.

      Note


      • Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.

      • When inserting the injector, be careful not to damage the O-ring.

    2. While turning the pressure regulator left and right, install it to the delivery pipe.

    3. A01EPY3

      Install the 2 bolts.

      Torque:
      10 N*m  { 107 kgf*cm, 7 ft.*lbf }
    4. A01EROC

      Connect the vacuum sensing hose to the pressure regulator.

    5. A01EP69

      Connect the No. 2 fuel tube to the pressure regulator Click here.

  2. INSTALL AIR CLEANER HOSE ASSEMBLY


    1. A01EOSKE01

      Install the air cleaner hose so that the protrusion of the air cleaner cap aligns with the groove of the hose as shown in the illustration.

    2. Tighten the 2 clamps.

      Torque:
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

    3. Connect the vacuum hose.

    4. Connect the No. 2 ventilation hose.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSPECT FOR FUEL LEAK


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG) and intelligent tester on.

      Note

      Do not start the engine.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed Control.

    4. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.

  5. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01EPLGE01

      Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.

  6. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the upper radiator support seal with the 3 clips.

  7. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.

  8. INSTALL ENGINE ROOM SIDE COVER RH


    1. Install the engine room side cover RH with the 7 clips.