FUEL PRESSURE REGULATOR INSTALLATION


  1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    1. Apply a light coat of gasoline or spindle oil to a new O-ring and install the O-ring to the pressure regulator.

      Note


      • Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.

      • When inserting the pressure regulator, be careful not to damage the O-ring.

    2. A01EQ0L

      While turning the pressure regulator left and right, install it to the delivery pipe.

    3. Install the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Install the No. 1 air hose to the pressure regulator.

    5. Connect the No. 2 fuel tube to the pressure regulator Click here.

  2. INSTALL AIR CLEANER CAP AND HOSE


    1. Install the air cleaner cap and hose, and then tighten the hose clamp.

      Torque:
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

    2. Attach the 4 clamps.

    3. Connect the mass air flow meter connector and attach the clamp.

    4. Connect the No. 2 PCV hose and No. 1 air hose.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01ER0YE01
      Text in Illustration
      *1 Grommet
      *2 Pin
      *3 Hook
      *4 Bracket

      Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.

  5. INSPECT FOR FUEL LEAK


    1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.


      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG) and turn the GTS on.

        Note

        Do not start the engine.

      3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

      4. Check that there are no leaks from the fuel system.

        If there are fuel leaks, repair or replace parts as necessary.

      5. Turn the engine switch off.

      6. Disconnect the GTS from the DLC3.

  6. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the upper radiator support seal with the 3 clips.

  7. INSTALL ENGINE ROOM SIDE COVER RH


    1. Install the engine room side cover RH with the 7 clips.

  8. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.