FUEL PUMP REASSEMBLY

Note

Do not disconnect the hoses indicated in the illustration.

A01EP3F

  1. INSTALL NO. 1 FUEL SUCTION SUPPORT


    1. Attach the 2 claws to the claw holes to install the fuel suction support.

  2. INSTALL FUEL MAIN VALVE ASSEMBLY


    1. A01ERRAE18
      Text in Illustration
      *1 New O-Ring

      Apply a light coat of gasoline to 2 new O-rings, and install them to the fuel main valve.

    2. A01ENRWE02
      Text in Illustration
      *1 Fuel Filter Case
      *2 O-Ring

      Install the fuel main valve to the fuel filter case.

      Note

      Make sure the O-rings are not cut or pinched during the installation.

  3. INSTALL FUEL PUMP


    1. A01EOB7

      Connect the fuel pump wire harness connector to the fuel pump.

    2. A01ENPRE02
      Text in Illustration
      *1 O-Ring
      *2 Spacer

      Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.

    3. Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.

  4. INSTALL NO. 1 FUEL SUB-TANK

    A01EPH6E02
    Text in Illustration
    *1 Fuel Tube

    Note

    Make sure that the fuel tube passes into the section marked by the circle.


    1. Attach the 3 claws to the claw holes and install the No. 1 fuel sub-tank.

    2. Attach the 3 claws to the claw holes.

    3. A01EN0RE03
      Text in Illustration
      *1 Jet Pump

      Connect the jet pump (labeled B) to the No. 1 fuel sub-tank.


      1. Attach the claw on the end of the tube to the claw hole.

    4. Connect the jet pump (labeled A) to the No. 1 fuel sub-tank.

    5. Connect the fuel pump connector.

  5. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01EQI8

      Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.

      Text in Illustration
      A01EO1M Slide

    2. Connect the fuel sender gauge connector.