DRIVE BELT REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01EN38E01

      Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01EQP2

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  6. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  7. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A01EN7K

      Remove the 10 bolts and No. 1 engine under cover.

  8. REMOVE FAN AND GENERATOR V BELT


    1. A01EPTXE02

      While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

      Tech Tips

      The pulley bolt for the belt tensioner has a left-hand thread.

    2. Remove the V belt.