ECM REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH (for LHD)


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System:

      After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CONNECTOR HOLDER BLOCK


    1. A01EPPPE01

      Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.

  5. REMOVE ECM


    1. A01ER3LE01

      Raise the 2 levers while pushing the locks on the 2 levers.

      Note

      Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

    2. Disconnect the 2 connectors.

    3. A01EQOG

      Remove the 4 bolts and ECM.

  6. REMOVE GASKET


    1. A01EQ44

      Peel off the gasket.

    2. A01ENFQE01

      Spray gasket remover or equivalent on the remaining tape of the gasket.

      Note

      When using gasket remover or equivalent, cover the ECM connectors with a cloth.

    3. A01EPF4

      Remove the tape of the gasket without using bladed objects.