IGNITION COIL AND SPARK PLUG INSTALLATION


  1. INSTALL SPARK PLUG


    1. Using a 16 mm plug wrench, install the 8 spark plugs.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  2. INSTALL IGNITION COIL ASSEMBLY


    1. for Bank 2:


      1. Install the 4 ignition coils with the 4 bolts.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      2. Connect the 4 ignition coil connectors.

      3. Attach the 3 clamps and connect the engine wire.

      4. Connect the water by-pass pipe with the 2 bolts.

        Torque:
        18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    2. for Bank 1:


      1. Install the 4 ignition coils with the 4 bolts.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      2. Connect the 4 ignition coil connectors.

      3. Attach the 4 clamps and connect the engine wire.

  3. INSTALL AIR CLEANER AND HOSE


    1. Install the air cleaner and hose with the 3 bolts, and then tighten the hose clamp.

      Torque:
      for bolt
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
      for hose clamp
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

    2. Attach the clamp and connect the mass air flow meter connector.

    3. Connect the No. 2 PCV hose and No. 1 air hose.

  4. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01ER0YE01
      Text in Illustration
      *1 Grommet
      *2 Pin
      *3 Hook
      *4 Bracket

      Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.

  5. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the upper radiator support seal with the 3 clips.

  6. INSTALL ENGINE ROOM SIDE COVER RH


    1. Install the engine room side cover RH with the 7 clips.

  7. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 7 clips.