THROTTLE BODY REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER LH


    1. Remove the 7 clips and engine room side cover LH.

      A01EN5SE01

  2. REMOVE ENGINE ROOM SIDE COVER RH


    1. Remove the 7 clips and engine room side cover RH.

      A01EPFTE01

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. A01ENLH

      Remove the 3 clips and upper radiator support seal.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. A01EQP2

      Remove the 3 bolts and 2 screws.

    2. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    1. A01EN7K

      Remove the 10 bolts and No. 1 engine under cover sub-assembly.

  7. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap and drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    3. Loosen the 2 cylinder block drain cock plugs and drain the coolant from the engine.

    4. Tighten the 2 cylinder block drain cock plugs.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    5. Tighten the radiator drain cock plug by hand.

      A01ERTTE01
      Text in Illustration
      *1 Reservoir Cap *2 Radiator Cap
      *3 Radiator Drain Cock Plug *4 Cylinder Block Drain Cock Plug

  8. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01EO82E01
      Text in Illustration
      *1 Grommet
      *2 Pin
      *3 Hook
      *4 Bracket

      Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

  9. REMOVE AIR CLEANER CAP AND HOSE


    1. A01ERFI

      Disconnect the No. 2 PCV hose and No. 1 air hose.

    2. Disconnect the mass air flow meter connector and detach the clamp.

    3. Detach the 4 clamps.

    4. Loosen the hose clamp and remove the air cleaner cap and hose.

  10. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01EOX8

      Disconnect the No. 4 water by-pass hose and No. 12 water by-pass hose.

    2. Disconnect the throttle position sensor and control motor connector.

    3. A01EPSN

      Remove the 4 bolts, throttle body with motor assembly and gasket.

    4. A01ESNY

      Remove the No. 12 water by-pass hose from the throttle body with motor assembly.

    5. A01ENPE

      Remove the No. 4 water by-pass hose from the throttle body with motor assembly.