RELAY ON-VEHICLE INSPECTION


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE SUSPENSION CONTROL RELAY (AHC)


    1. Remove the suspension control relay from the engine room relay block.

  4. INSPECT SUSPENSION CONTROL RELAY


    1. A01EN96E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage is applied to terminals 1 and 2 Below 1 Ω

      • If the result is not as specified, replace the suspension control relay.

  5. INSTALL SUSPENSION CONTROL RELAY


    1. Install the relay to the engine room relay block.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.