SUSPENSION CONTROL ECU INSTALLATION


  1. INSTALL SUSPENSION CONTROL ECU


    1. A01EQ7E

      Attach the wire harness clamp and connect the connector.

    2. Install the ECU with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL REAR SIDE NO. 2 AIR DUCT (w/ Heater)

    A01EQHC

    1. Install the duct with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    A01ERFB

    Tech Tips

    When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. Connect the thermistor connector.

    2. Attach the 19 clips and 2 claws to install the quarter trim panel.

    3. Install the clip.

      A01ENWJ
    4. A01EQO3E02

      Install the rear No. 2 seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.

    5. A01EOE1

      Install the rear No. 1 seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    6. A01ESN6

      Attach the 3 claws to install the cover.

  4. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    A01EQA6

    1. Attach the 6 clips and 4 claws to install the support plate.

  5. INSTALL REAR DOOR SCUFF PLATE LH

    A01EN6Q

    1. w/o Illumination Type Front Door Scuff Plate:


      1. Attach the 3 claws and 4 clips to install the scuff plate.

      2. Install the screw.

    2. A01ERAD

      w/ Illumination Type Front Door Scuff Plate:


      1. Attach the 3 claws and 4 clips to install the scuff plate.

      2. Install the screw.

  6. INSTALL REAR STEP COVER

    Tech Tips

    Use the same procedure to install the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Attach the 2 claws to install the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Attach the 4 claws to install the step cover.

  7. CLEAN REAR NO. 2 SEAT ASSEMBLY LH


    1. Install the rear No. 2 seat assembly LH Click here.

  8. INSTALL REAR NO. 2 SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION


    1. Perform the vehicle height offset calibration Click here.

  11. PERFORM ZERO POINT CALIBRATION OF G SENSOR


    1. Perform the zero point calibration of the G sensor Click here.

  12. ADJUST HEADLIGHT ASSEMBLY


    1. Adjust the headlight Click here.