SUSPENSION CONTROL ECU REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


    1. Remove the rear No. 2 seat assembly LH Click here.

  4. REMOVE REAR NO. 2 SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  5. REMOVE REAR STEP COVER

    Tech Tips

    Use the same procedure to remove the step cover on the other side.


    1. A01EQ9D

      w/o Illumination Type Front Door Scuff Plate:

      Detach the 2 claws and remove the step cover.

    2. A01EQ94

      w/ Illumination Type Front Door Scuff Plate:

      Detach the 4 claws and remove the step cover.

  6. REMOVE REAR DOOR SCUFF PLATE LH

    A01EN6Q

    1. w/o Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

    2. A01ERAD

      w/ Illumination Type Front Door Scuff Plate:

      Remove the rear door scuff plate.


      1. Remove the screw.

      2. Detach the 3 claws and 4 clips, and remove the scuff plate.

  7. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    A01EQA6

    1. Detach the 6 clips and 4 claws, and remove the support plate.

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    A01ERFB

    Tech Tips

    When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. A01ESN6

      Detach the 3 claws and remove the cover.

    2. A01EOE1

      Remove the bolt and rear No. 1 seat belt anchor.

    3. A01EQO3

      Remove the bolt and rear No. 2 seat belt anchor.

    4. Remove the clip.

    5. Detach the 19 clips and 2 claws.

    6. Disconnect the thermistor connector and then remove the quarter trim panel.

      A01ENWJ

  9. REMOVE REAR SIDE NO. 2 AIR DUCT (w/ Heater)

    A01EQHC

    1. Remove the 3 screws and duct.

  10. REMOVE SUSPENSION CONTROL ECU


    1. A01EQ6G

      Remove the 2 bolts and ECU.

    2. Detach the wire harness clamp and disconnect the connector.