HEIGHT CONTROL SENSOR (for Front Side) REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL

  4. REMOVE FRONT FENDER APRON SEAL FRONT LH


    1. A01EPDR

      Using a clip remover, remove the 4 clips and fender apron seal.

  5. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A01EOW7

      Disconnect the connector.

    2. Remove the nut, bolt and sensor.