ACTIVE HEIGHT CONTROL PUMP AND MOTOR REMOVAL


  1. DISCHARGE SUSPENSION FLUID PRESSURE


    1. A01ERV4

      Connect a hose to the bleeder plug for the height control accumulator and loosen the bleeder plug.

    2. Discharge the suspension fluid pressure.

    3. After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

  2. REMOVE REAR QUARTER PANEL MUDGUARD RH

    A01ENPF

    1. Remove the clip.

    2. Using a T30 "TORX" socket, remove the 8 screws and mudguard.

  3. REMOVE REAR BUMPER COVER


    1. for Standard:

      Remove the bumper cover Click here.

    2. w/ Towing Hitch:

      Remove the bumper cover Click here.

    3. w/ Pintle Hook:

      Remove the bumper cover Click here.

  4. REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

    A01ES3R

    1. Remove the 2 screws, 2 grommets and protector.

  5. REMOVE FUEL TANK FILLER PIPE PROTECTOR


    1. A01EQ64

      Using a T30 "TORX" socket wrench, remove the 3 screws, 2 grommets and pipe protector.

  6. DISCONNECT REAR NO. 6 HEIGHT CONTROL TUBE


    1. A01ER7L

      Using a union nut wrench, disconnect the No. 6 height control tube from the pump and motor.

  7. REMOVE HEIGHT CONTROL TUBE CLAMP


    1. A01EPVEE01

      Disconnect the tube clamp from the hose, then remove the 2 bolts and tube clamp.

  8. REMOVE HEIGHT CONTROL PUMP AND MOTOR ASSEMBLY


    1. A01ENS5

      Disconnect the 2 connectors and 3 clamps.

    2. A01ENUI

      Remove the 3 bolts and pump and motor.