ACTIVE HEIGHT CONTROL SUSPENSION, Diagnostic DTC:C1794

DTC Code DTC Name
C1794 Height Control OFF Switch Circuit (Test Mode DTC)

DESCRIPTION

This is the height control system main switch. When the height control switch is pushed, the height control OFF indicator light lights up and height control turns off.

The off condition of the height control will not be canceled until the height control switch is pushed again or the vehicle is driven.

DTC Code Detection Condition Trouble Area
C1794 The test mode procedure is performed.
  • Harness or connector

  • Integration control and panel (Height control OFF switch)

  • Suspension control ECU

WIRING DIAGRAM

A01EQ3IE10

INSPECTION PROCEDURE

Note


  • Before performing troubleshooting, inspect the connectors of related circuits.

  • If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed Click here.

PROCEDURE


  1. INSPECT INTEGRATION CONTROL AND PANEL (HEIGHT CONTROL OFF SWITCH)


    1. Remove the integration control and panel Click here.

    2. A01EP1PE14

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4 (N) - 8 (E) Height control OFF switch is pushed. Below 1 Ω
      Height control OFF switch is not pushed. 10 kΩ or higher

    NG
    OK
  2. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - SWITCH AND BODY GROUND)

    A01EQ8PE11

    1. Disconnect the K30 ECU connector.

    2. Disconnect the V4 integration control and panel connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K30-11 (TD) - V4-4 (N) Always Below 1 Ω
      K30-11 (TD) - Body ground Always 10 kΩ or higher
      V4-8 (E) - Body ground Always Below 1 Ω

    NG
    OK