HEIGHT CONTROL ACCUMULATOR REMOVAL


  1. REMOVE TAILPIPE ASSEMBLY


    1. Remove the bolt, clamp and gasket.

    2. Remove the tailpipe from the 2 exhaust pipe supports.

    3. Remove the bolt and clamp, and then disconnect the tailpipe from the center exhaust pipe.

  2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    1. Remove the 4 bolts.

    2. Remove the center exhaust pipe from the 3 exhaust pipe supports.

    3. Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.

  3. REMOVE HEIGHT CONTROL UNIT INSULATOR

    A01EO08

    1. Remove the 3 bolts and insulator from the control unit.

  4. DISCHARGE SUSPENSION FLUID PRESSURE


    1. A01ERV4

      Connect a hose to the bleeder plug for the height control accumulator and loosen the bleeder plug.

    2. Discharge the suspension fluid pressure.

    3. After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

  5. REMOVE NO. 7 HEIGHT CONTROL TUBE

    A01ENL2

    1. Using a union nut wrench, remove the control tube from the control valve and pump accumulator.

  6. REMOVE SUSPENSION CONTROL PUMP ACCUMULATOR ASSEMBLY

    A01ER5G

    1. Remove the 3 nuts and pump accumulator.