FRONT AXLE HUB ON-VEHICLE INSPECTION


  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. A01ENEO

      Remove the bolt and nut, and disconnect the brake tube bracket from the steering knuckle.

    2. A01EOKP

      Remove the 2 bolts and disconnect the disc brake caliper from the steering knuckle.

      Note


      • Do not disconnect the flexible hose from the disc brake caliper.

      • Do not twist or bend the flexible hose.

  3. REMOVE FRONT DISC


    1. A01ESBCE01

      Put matchmarks on the front disc and the axle hub if planning to reuse the disc.

    2. Remove the front disc.

  4. REMOVE FRONT AXLE HUB GREASE CAP LH


    1. A01ESO7

      Using a screwdriver and hammer, remove the axle hub grease cap.

      Note

      Do not damage the axle hub.

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A01EOF8

      Using a dial indicator, measure the looseness near the center of the axle hub.

      Maximum looseness
      0.05 mm (0.00197 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

  6. INSPECT FRONT AXLE HUB RUNOUT


    1. A01EQJ6

      Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

      Maximum runout
      0.08 mm (0.00315 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

  7. INSTALL FRONT AXLE HUB GREASE CAP LH


    1. Install the axle hub grease cap.

      Note

      Make sure to securely fit the grease cap to the axle hub.

  8. INSTALL FRONT DISC


    1. A01ESBCE01

      Align the matchmarks, and then install the front disc.

      Tech Tips

      When replacing the front disc with a new one, select the installation position where the front disc has the minimum runout.

  9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. A01EOKP

      Connect the front disc brake caliper and install 2 new bolts.

      Torque:
      99 N*m  { 1010 kgf*cm, 73 ft.*lbf }

      Note


      • Do not twist the flexible hose.

      • Make sure that the bolts are free from damage and foreign matter.

      • Do not overtighten the bolts.

    2. A01ENEOE01

      Connect the brake tube bracket to the steering knuckle with the bolt and nut.

      Torque:
      for bolt
      31 N*m  { 316 kgf*cm, 23 ft.*lbf }
      for nut
      13 N*m  { 132 kgf*cm, 10 ft.*lbf }

  10. INSTALL FRONT WHEEL

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }