FRONT DRIVE SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE FRONT AXLE INBOARD JOINT SET SETTING SHAFT SNAP RING


    1. A01ENS2

      Using a screwdriver, remove the snap ring from the inboard joint shaft.

  2. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT SETTING CLAMP


    1. Using a side cutter, cut the inboard joint boot setting clamp and remove it.

  3. REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT SETTING CLAMP


    1. Using a side cutter, cut the inboard joint boot setting clamp and remove it.

  4. DISCONNECT FRONT AXLE INBOARD JOINT BOOT


    1. A01EMYVE01

      Disconnect the inboard joint boot from the inboard joint shaft set.

  5. REMOVE FRONT AXLE INBOARD JOINT SHAFT


    1. A01ER20E01

      Place matchmarks on the inboard joint shaft and outboard joint shaft.

      Note

      Do not punch the marks.

    2. Using a screwdriver, remove the snap ring from the inboard joint shaft.

    3. Remove the inboard joint shaft from the outboard joint shaft.

    4. A01ERL4E04

      Place matchmarks on the outboard joint shaft, inner race and cage.

      Note

      Do not punch the marks.

    5. Remove the 6 balls.

    6. Slide the cage to the outboard joint side.

    7. A01EODJ

      Using a snap ring expander, remove the snap ring.

    8. A01ENYG

      Using a brass bar and hammer, tap off the inner race.

      Note

      Be careful not to damage the inner race.

    9. Remove the cage.

  6. REMOVE FRONT AXLE INBOARD JOINT BOOT


    1. Remove the inboard joint boot from the outboard joint shaft.

  7. REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT SETTING CLAMP


    1. Using a side cutter, cut the outboard joint boot setting clamp and remove it.

  8. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT SETTING CLAMP


    1. Using a side cutter, cut the outboard joint boot setting clamp and remove it.

  9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT


    1. A01EOY8E01

      Remove the outboard joint boot from the outboard joint shaft.

  10. REMOVE DUST SEAL

    A01EQMA

    1. Fix the outboard joint shaft assembly in a vise between aluminum plates.

      Note

      Do not overtighten the vise.

    2. Using a screwdriver and a hammer, remove the dust seal.

  11. REMOVE FRONT DRIVE SHAFT DUST COVER LH


    1. A01EQIVE01

      Using SST and a press, press out the dust cover.

      SST
      09950-00020

      Note

      Do not drop the inboard joint shaft.