TRANSFER ASSEMBLY INSTALLATION


  1. INSTALL TRANSFER ASSEMBLY


    1. A01EMWS

      Install the transfer with the 8 bolts.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      Take care not to damage the adaptor oil seal with the transfer input shaft spline.

  2. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY

    Click here

  3. ADD TRANSFER OIL


    1. A01ER8A

      Install a new gasket to the drain plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. A01ER2OE08

      Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. A01ERXS

      Install a new gasket to the filler plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    5. A01EP6D

      Install the lower transfer case protector with the 7 bolts.

      Torque:
      14 N*m  { 139 kgf*cm, 10 ft.*lbf }
    6. A01EO9X

      Install the transfer heat insulator with the 4 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    7. A01ERO9

      Install the transfer dynamic damper with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  4. CHECK FOR TRANSFER OIL LEAK