TRANSFER ASSEMBLY INSTALLATION


  1. INSTALL TRANSFER ASSEMBLY


    1. A01EMWS

      Install the transfer with the 8 bolts.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      Take care not to damage the adaptor oil seal with the transfer input shaft spline.

  2. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY


  3. ADD TRANSFER OIL


    1. A01ER8A

      Install a new gasket to the drain plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. A01ER2OE08

      Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. A01ERXS

      Install a new gasket to the filler plug and then install the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    5. A01EP6D

      Install the lower transfer case protector with the 7 bolts.

      Torque:
      14 N*m  { 139 kgf*cm, 10 ft.*lbf }
    6. A01EO9X

      Install the transfer heat insulator with the 4 bolts.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }
    7. A01ERO9

      Install the transfer dynamic damper with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  4. CHECK FOR TRANSFER OIL LEAK