OIL PUMP REASSEMBLY


  1. INSTALL FRONT OIL PUMP OIL SEAL

    A01EODVE01

    1. Using SST and a hammer, tap in a new oil seal.

      SST
      09950-60010   ( 09951-00650 )
      09950-70010   ( 09951-07100 )

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    2. Coat the lip of the oil seal with MP grease.

  2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR

    A01EP0O

    1. Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR

    A01EOA2

    1. Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  5. INSTALL FRONT OIL PUMP BODY O-RING

    A01EPGCE01

    1. Coat a new O-ring with ATF and install it to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY

    A01EQRHE01

    1. Align the stator shaft with the bolt holes.

    2. Install the 17 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  7. INSTALL CLUTCH DRUM OIL SEAL RING

    A01EQNZE02

    1. Coat 3 new oil seal rings with ATF.

    2. Squeeze the ends of the 3 oil seal rings together so that the overlap distance is 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

      Note

      Do not excessively widen the rings.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  8. INSPECT OIL PUMP DRIVE GEAR ROTATION

    A01EQXO

    1. Place the oil pump assembly on the torque converter clutch.

    2. Check that the drive gear rotates smoothly.

    3. Remove the oil pump assembly from the torque converter.

  9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING

    A01ENKNE01

    1. Coat a new O-ring with ATF and install it to the oil pump.