PATTERN SELECT SWITCH INSPECTION


  1. REMOVE NO. 1 PATTERN SELECT SWITCH ASSEMBLY

    A01EPZJE03

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4 (P) - 3 (E) Pattern select (PWR) switch on Below 1 Ω
      4 (P) - 3 (E) Pattern select (PWR) switch off 10 kΩ or higher
      2 (2ND) - 3 (E) Pattern select (2ND) switch continuously pressed Below 1 Ω
      2 (2ND) - 3 (E) Pattern select (2ND) switch released 10 kΩ or higher

      If the result is not as specified, replace the No. 1 pattern select switch assembly.