VALVE BODY ASSEMBLY INSTALLATION


  1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

    A01EPQDE04

    1. Install the spring and check ball body.

    2. A01ENF0E01

      Insert the pin of the manual valve into the hole of the manual valve lever.

    3. A01EOYAE01

      Install the 19 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      36 mm (1.42 in.) for bolt A

      25 mm (0.984 in.) for bolt B

      45 mm (1.77 in.) for bolt C

      50 mm (1.97 in.) for bolt D

    4. Install the detent spring and detent spring cover with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. CONNECT TRANSMISSION WIRE

    A01EN5YE02

    1. Connect the 9 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.41 in.) for bolt B

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01EQU2

    1. Coat a new O-ring with ATF and install it to the oil strainer.

    2. Install the oil strainer with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01ENINE01

    1. Install the 4 transmission oil cleaner magnets to the oil pan.

    2. A01EQHKE01

      Install a new gasket and the oil pan with the 12 bolts.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

      Note

      A01ENE9E01

      • Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.

      • Install the gasket so that there is no slack in the gasket, and make sure the entire circumference of the seal surface is level.

      • Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.

      • When tightening the bolts of the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal surface.

  5. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.

  6. INSTALL OIL PAN PROTECTOR ASSEMBLY


    1. Install the oil pan protector assembly with the 4 bolts.

      Torque:
      63 N*m  { 642 kgf*cm, 46 ft.*lbf }

  7. INSTALL NO. 2 ENGINE UNDER COVER


    1. Install the No. 2 engine under cover with the 2 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }