TRANSMISSION WIRE REMOVAL


  1. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01ERKF

      Remove the 2 bolts and No. 2 engine under cover.

  2. REMOVE OIL PAN PROTECTOR ASSEMBLY

    A01EPTF

    1. Remove the 4 bolts and oil pan protector.

  3. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01EQHKE01

      Remove the 12 bolts, oil pan and gasket from the transmission.

      Note

      Some fluid will remain in the oil pan. Remove all the bolts, and carefully remove the oil pan assembly.

    2. A01EQ4SE01

      Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A01EQU2

      Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  6. DISCONNECT TRANSMISSION WIRE

    A01EN5YE01

    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the 2 ATF temperature sensors.

    3. Disconnect the 9 connectors from the solenoid valves.

  7. REMOVE TRANSMISSION WIRE

    A01ES7ZE01

    1. Disconnect the 2 wire connectors.

      Tech Tips

      Detach the claw, press down the lever, and then disconnect the transmission wire connector.

    2. A01ENU5

      Remove the 2 bolts and pull out the 2 transmission wires.